Part1: Construction has tricks
The home decoration project is a must-have project for wall decoration. If the wall decoration is not handled properly, it will leave many regrets for the future. Moreover, it is not uncommon for the wall decoration to be cut corners. Therefore, the owner must Pay more attention and avoid regretting the decoration.
Regret 1: Wall paint brushing things
Latex paint is the most common wall decoration material at present, and can be painted, rolled or sprayed in specific construction. If the workers are not serious or perfunctory during construction, small color differences often occur. Especially with deeper emulsion paints, this problem is more likely to occur.
Responsive measures: Before the use of latex paint, it is necessary to add a certain amount of fresh water, and the latex paint must be used up once. Paints of the same color are also best painted once. If the wall needs to be repaired after construction, the whole wall should be repainted again.
Regret 2: The tile is not firmly bonded
Secondly, it is also one of the phenomena of cutting corners because of poor adhesion of paving bricks. Placing bricks and tiles is a technical process. If workers cut corners, they are most prone to problems such as empty tiles, missing seams, and cement and adhesives used for laying tiles. If the ratio is unreasonable, there will be problems such as shedding.
Response measures: According to the “Quality Acceptance Criteria for Family Room Decoration Projects†promulgated by the Beijing Municipal Construction Committee, it is required that the wall and floor tiles should be flat and firm, with clear patterns, no dirt and grout marks, and the surface color is basically the same, with even joints and no cracks in the plates. , drop angles and missing edges, local emptying may not exceed 5% of the total.
Regret 3: Bare wall construction
In addition, buried pipelines must be slotted on walls and floors before they can be buried. A few workers perform barbaric construction during the grooving operation, which not only damages the building load-bearing structure, but also may cause damage to other nearby pipelines. This is also one of the acts of cutting corners.
Responsive measures: Prior to construction, reconfirm the direction and location of the pipeline with the construction team leader. For different wall structures, the requirements for slotting are not the same: the walls of the load-bearing wall in the house are not allowed to be slotted, and the wall with the insulating layer is easy to cause cracking on the surface after being slotted, and on the ground Slotting, but also be careful not to damage the floor, causing trouble to the residents downstairs.
Regret 4: bad gap repair
In addition, some of the places where the walls meet the doors and windows, as well as the docking of two different colors of paint, are exactly where the workers are often perfunctory. You will often see mixed paints between latex paint and wood, with various problems at the joints.
Response: The treatment of joints is very important, and you must supervise the workers in the construction process. If there are two colors of paint on the wall facing each other, it is necessary to apply adhesive tape on the edge of the first color during construction, and then apply another color of paint on it, so that the construction is completed. After tearing off the tape, the entire seam can be very neat.
Common Stealing & Decrease Means Home Decorations Tire Decoration Decorating Paints Cement Latex Paints Switch Living Room Wall Color Decoration Living Room Floor Tiles Bathroom Tiles Bathroom Doors Bathroom Tiles Colors Bathrooms Bathrooms Bathrooms Bathrooms Leaks Bedroom Lighting Tiles Tiles Kitchen Tiles ld Tiles Small Bedrooms Floor Tiles Decorations Home Bedroom Lamps
Shower Arm,Adjustable Shower Arm,Shower Head Arm,Delta Shower Arm
Moon Shower Sanitaryware Co.,Ltd , https://www.moonshowerglobal.com