The washing machine is one of the most commonly used electrical appliances in our daily life. It saves a lot of time when we are busy at work. So today I will share with you how to use the washing machine correctly?
There are four tips below, let's learn together, friends!
Tip 1: The "three essentials" when the washing machine is placed should be stable on a well-ventilated, dry and hard ground. Use a three-core power supply flat foot plug and socket. The height of the socket is preferably 1.8 meters and 2 meters above the ground. 1 meter-1.5 meters, 0.6 meters away from the ditch.
Tip two: "three don'ts" during installation: do not place in direct sunlight and close to heat sources, do not place in corrosive gases such as gas, and do not forget to connect the washing machine to the ground wire reliably.
Tip three: "Ten Don'ts" when using the washing machine: Do not overweight laundry, do not use boiling water or high temperature water for washing, do not move the water-filled washing machine, especially do not move the washing machine while it is working, do not vigorously operate various Switch button, don't change the washing selection switch at will. If you need to change, you should reset the timer or disconnect it from the power supply, do not reverse the timer, do not let the timer be exposed to water, and do not idling for a long time, so as not to cause the heating and aging of the sealing ring on the pulsator shaft. Do not use the washing machine continuously for a long time, do not use the washing machine in an environment below 0 degrees, and do not allow water storage, and do not use gasoline or alkaline liquid to scrub the grease on the surface of the washing machine.
Tip four: "Six points" when using the washing machine: remove all the contents of the pocket, especially the hard objects must be taken out and washed, otherwise the wall or pulsator will be damaged Make the shaft wear and leak. The filter in the drum of the washing machine should be cleaned frequently to make the drainage smooth; pay attention to the amount of water injected into the washing machine; and prevent the water from splashing on the control board to prevent it from seeping into the electrical control part. Turn off the power in time after use; drain the water after washing, dry the inside and outside of the washing machine with a soft cloth, and don't put on the cover immediately after washing; regularly add lubricant to the mechanical transmission part of the washing machine. After using the pulsator shafts and bearings for 3 to 5 years, the grease should be replaced or lubricated.
Editor in charge: Gococo Coco
Alumina Ceramic Standard Parts
Ceramic parts are mechanical parts made of special ceramic materials through mixing, forming, sintering and processing.
The special ceramic materials mentioned may be oxide ceramics, nitride ceramics, boride ceramics, carbide ceramics, and the like.
As an inorganic non-metallic material, special ceramic materials have many properties that metal materials do not have, such as: high strength, high hardness, high modulus of elasticity, high temperature resistance, wear resistance, corrosion resistance, oxidation resistance, thermal shock resistance. .
Alumina Ceramic Standard Parts,Alumina Ceramic Grinder Parts ,Ceramic Silicon Carbide,Ceramic Part
Dongguan Haikun New Material Co., Ltd. , https://www.hkceram.com