Water-in-water colorful paint is a new paint product in the 21st century, which brings new development advantages to the building decoration industry. However, the construction quality of the paint product needs to be very particular. It is a complicated process. We generally consider the following conditions. You can:
1, raw material selection: good materials are the basis of the quality of the finished product, to conduct a serious examination on the ground. See if you really have technical strength, experimental conditions and application experience. In addition, it is best to use a company's products from the base of the putty and the color and finish of the main paint.
2, batch procurement: When the customer receives a larger left upper, it is necessary to carry out the calculation of the materials used for recognition. Buy as much as possible, especially the main color point. The more batches purchased, the more likely it is to have quality problems. Manufacturers are also trying to solve the batch chromatic quality problem but it is almost impossible. It is only possible to minimize batch stability.
3, the substrate conditions: our paint is generally done in the insulation and also directly to the ordinary wall surface but not much. The substrate must be carefully and strictly inspected during the construction of the outer coating. If you can meet the construction requirements, if you can't reach it, you should barely deal with it or repair it as soon as possible. Our veneer is no better. If there is a quality problem with the substrate, then we can't escape the problem. There are already a lot of problems in the actual construction.
4, weather conditions: exterior wall paint belongs to the outdoor surface will have a lot of weather reasons will directly affect the quality of our project. Such as temperature, wind, precipitation, etc.
5. Construction management: The construction of the external wall is a relatively complicated project. Especially the construction of colorful paints should be more careful. For example, the spraying of colored dots should avoid novice work as much as possible. Before the construction, it is necessary to carry out the preliminary training work to coordinate the work of everyone. The less the master who sprays the main paint, the better. It is better to have only one person to spray but it is a bit unrealistic. At least a few masters must be called together to unify the effect of spraying.
As with the colorful paint products of Asdan and the good construction environment and good construction team, our urban architecture will be more beautiful.
Globe Valves and angle valves are designed for throttling or regulating flow in commercial and industrial applications. Bronze, cast iron, or cast ductile iron materials. Threaded, flanged, or solder end connections.
Angle valves for use in commercial and industrial applications. Typical services include hot and cold water, HVAC, steam, compressed air, gas and other general utility services.
Vacuum angle valve is used for turn on or shut off the airflow in the vacuum pipeline, the applicable media is air and non-corrosive gases.
It has two structures, one is angle type and another is a 3-way type within an ISO-KF or ISO-F various flange end pre-pump port.
a) Small diameter (≤DN50) valve body are precision investment casting.
b) Large diameter (> DN50) valve body are molding shaped seamless steel or steel plate.
c) Bellows sealed structure can withstand 150ºCtemperature, metal sealed structure can withstand 450ºCtemperature.
d) Can install on any position to control the airflow in the vacuum pipeline, as an on-off valve purpose
Angle Valves, Angle Globe Valves, Brass Angle Valve, Zinc Angle Valve
ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.cn-kingsir.com