Three screw pump installation instructions: (1) pump suction, discharge pipe diameter not less than the pump inlet and outlet diameter, the inlet pipe to shorten and reduce unnecessary losses (such as elbows, etc.), the pump installation height should ensure that the pump Do not exceed the allowable suction vacuum height when working. (2) The pipe should be pipe rack, the pump is not allowed to withstand the load of the pipeline. (3) Before installation, it is necessary to clean up the suction and discharge pipelines, especially the welding slag of the suction pipe must be completely removed to avoid biting into the pump. (4) suction pipe should be installed filters, the filter is 40-80 mesh, the effective filtration area should be larger than the pump suction diameter 20-30 times. (5) pump inlet and outlet connections vacuum and pressure gauge, in order to observe the working status of the pump. (6) If more than two pumps are connected in parallel on the same pipe, a check valve must be installed at the pump outlet to ensure the normal operation of the pump. (7) The location of the installation of the pump should be spacious, easy maintenance. (8) The unit is placed on the foundation buried bolt, find the positive and then tighten the anchor bolt. (9) After connecting the pipe and determining the motor steering coupling, the tolerance of the coaxiality of the coupling is 0.1mm, and the tolerance of the clearance of the two coupling ends is 2mm. (10) 3-4 hours after the unit running for the final inspection, if no adverse phenomena, then that the installation of qualified.
Square Nuts,Stainless Steel Square Nut,Square Machine Screw Nuts,Square Nuts With Single Chamfer
Kunshan Liyue Hardware Products Co.,Ltd , https://www.fixlyhardware.com