In the early stage of the renovation, it is very important to first check the house. Especially some new houses and rough houses. Detailed inspection of the quality of the house, including walls, doors and windows, balconies, etc., is required.
This also relates to whether the house has problems, what needs to be done during the construction, and the contents of the budget offer. If there is a problem, you can contact kfs in time to avoid the expansion of later problems.
First, check the house for cracks
1. Look carefully at the floor and top of the house for cracks. If there are cracks, look at what kind of cracks.
In general, the crack parallel to the room beam is a quality problem, but there is basically no danger, and it will not hinder the use after repair. If the crack is at an angle of 45 degrees to the corner of the wall or perpendicular to the beam, it indicates that the settlement of the house is serious and there are structural quality problems.
2. Look at the exterior walls of the house for cracks. If there are cracks, it is a serious quality problem.
3. Look at the load-bearing wall for cracks. If the crack runs through the entire wall and is worn behind, it indicates that there is a danger in the house. For such houses, the purchaser must not report the luck.
Second, check the house for tilt
A heavy rope can be used to tie a heavy object on the roof, and the wall is lowered to the wall foot to check the inclination from the surrounding.
Third, check the house for leaks
Buyers should pay attention to the ground and top water seepage of the house. Care should be taken to check whether the wall of the house is discolored, blistering, peeling, or ash. These are signs of leakage.
Also check the kitchen, bathroom, balcony top and pipe connections for leaks.
Fourth, check the wall, the ground
1. For the living room that has been roughly renovated, check whether the wall is flat, and there must be no obvious ups and downs. Seeing the wall has become the primary problem of house acceptance.
Acceptance of this, it is best to check the house on the second day before heavy rain. At this time, if there is a problem with the wall, it is almost indestructible. In addition to water seepage, there is a problem with the wall, whether the wall is cracked.
2. Check the wall for lime "explosion". If the lime does not mature enough or the sediment in the cement is too much or the mixing is uneven, when the "explosion point" is hit with an iron, a large area of ​​looseness and shedding will be found.
3, the ground should be smooth, can not sand.
4, check the kitchen, bathroom wall tile masonry is qualified, bricks can not be cracked, can not be hollow, must be solid.
5. Check whether the bathroom and kitchen floor have been treated for slopes.
Mainly for natural drainage (can not be tilted to the door, or water should flow into the room), see if the water can be unobstructed to the water outlet.
Sixth, check the doors and windows
Here, it is dominated by the acceptance window. The key point of acceptance is the tightness of the acceptance window and the balcony door.
The most troublesome thing about the acceptance of the seal of the window is that it can only be tested in good rain. However, it can generally be confirmed by checking whether the sealing strip is intact or firm.
The balcony door generally depends on the level difference between the inside and outside of the balcony door. I have seen a situation where the level of the balcony is the same as the level of the interior, so it is difficult to avoid the problem of rainwater infiltration in heavy rain.
Whether the density of doors and windows is appropriate, whether the opening and closing is smooth. Whether the door frame, the edge of the window frame, etc. are vulnerable to impact, there should be no gaps.
Socket Wrench,Wire Stripper,Crescent Wrench,Phillips Screwdriver
Ningbo Hoya Electronic Commerce Co., LTD , https://www.jauhitools.com